Tag Archives: colour matching gel-coat

Bruised boat, bruised ego

starboard_hull_damageLast summer I was merrily heading into Toronto’s inner harbour through the Eastern Gap*. I was busy lounging behind the wheel and talking with friends when one casually said “we are headed straight for a big green thing”.  That big green thing being the big steel buoy making the inner entrance to the Eastern Gap. I turned the boat to port and the wake pushed the buoy away from the a boat,  only to have the buoy swing back back with a vengeance and smack the hull just below the rub rail on starboard. Ouch.
The impact shattered the gel-coat and the underlying layers of fibreglass. It didn’t look too bad and I left it for the season as it is well above the waterline close to the forward sling marks.

What king of sailor sails straight into a big green buoy that he knows is there… ugh.

Repair #1
20160504_163350_repair_complete
Finished repair.

Peeling back the layers of crushed gel-coat and fiberglass mat, I discovered the damage was much more extensive than it appeared. There was considerable de-lamination between the many layers however the lowest layers were just bruised, not cracked. The damage also extended in a much larger radius then the gel-coat damage itself, presumably from the fibreglass flexing in.
I couldn’t access the damage from the interior unless I did a massive cabin disassembly, so rather than cut a hole , I decided to grind down and re-glass from the outside, leaving the bottom most layer intact.

After applying a few layers of mat and resin I levelled the patch with a sander and enlarged the grind. You can see the wound get bigger in the photos. Complicating the repair job was an unusually cold spring. I used a heat gun to warm the hull first and then gently warm the repair at several intervals to ensure the resin kicked.

Continue reading Bruised boat, bruised ego